TYPE B Assembly Introduction:
Note: The Tube can
work with either Single-
end Power Input or
Double-end Power Input
TYPE A Instructions:
1. Switch-off Power to the Luminaire.
2. Remove Diffuser (if provided).
3. Remove the existing Fluorescent Lamps
from the Luminaire.
4. Install the LED Tube Lamp.
5. Install Diffuser
(if removed in step 2)
6. Switch on Power to the Luminaire.
7. Before Installation, check Specifications for
the most Current Ballast Compatibility
List. If not Compatible, insert LED Tubes
according to Type B Installation Instructions.
TYPE A - Assembly Introduction:
Type A Installation Guide:
1. DISCONNECT POWER TO LUMINAIRE
Disconnect Power to Luminaire or Circuit
(if possible). Ensure all Power is OFF by
using a Voltmeter or other approved
method to confirm.
Instructions: Type B Installation Guide:
2. REMOVE EXISTING TUBE LAMP(S)
a. Remove Troffer Lens, if present.
b. Remove existing Fluorescent
Tube by Rotating One-quarter turn
and sliding Lamp(s)
c. Remove Ballast Cover. (Cover may
be secured with Screws or Tabs).
3 a. RETROFIT LUMINAIRE - Retrofit Luminaire with Inductive Ballast
Disconnect the Wires
between Starter and
Ballast according to the
figure above.
Connect two Wires to
Branch Circuit L and N
according to the
figure above.
Disconnect the Wires
between Starter and
Ballast according to the
figure above.
L
L
OR
OR
4. INSERT LED TUBES
a. Ensure both the ends of the LED Tube are aligned with Socket, then insert LED Lamp in the
normal way by sliding Pins into Sockets and rotating a quarter turn until the LED Tube locks in place.
b. LED Lamps are now fully installed.
c. Replace Troffer Lens, if present.
d. After modification completed. Attach the Replacement Marking and Cautionary Label to a
visible place on the Luminaire and keep it visible after installation.
5. RESTORE THE POWER OF LUMINAIRE
Restore Power to Circuit/Luminaire and test Light. If necessary, adjust position of LED Tube,
and enjoy your new LED Tube!
3 b. RETROFIT LUMINAIRE - Retrofit Luminaire with Electronic Ballast
OR
OR
Disconnect the Wires
between Ballast
according to the
figure above.
Connect two Wires to
Branch Circuit
L and N according
to the figure above.
3 c. RETROFIT LUMINAIRE -Retrofit Luminaire with Two Lamps and One Electronic Ballast
OR
OR
OR
Disconnect the Wires
between Ballast
according to the
figure above.
Connect two Wires to
Branch Circuit L and N
according to the
figure above.
3 e. RETROFIT LUMINAIRE -Retrofit Luminaire with Four Lamps and One Electronic Ballast
Disconnect the Wires
between Ballast
according to the
figure above.
Connect two Wires to
Branch Circuit L and N
according to the
figure above.
OR
OR
OR
3 d. RETROFIT LUMINAIRE -Retrofit Luminaire with Three Lamps and One Electronic Ballast
OR
OR
OR
Disconnect the Wires
between Ballast
according
to the figure above.
Connect two Wires to
Branch Circuit L and N
according to the
figure above.
