www.codipro.net - [email protected]
25, Salzbaach – LU-9559 WILTZ – Tél : +352 26 81 54 1 - Fax : +352 81 05 17
02.2021
QLR instruction manual - translation of the French original version
Conform with the Machinery Directive 2006/42/EC
Instruction manual
QLR
Quick Lift Ring
CODIPROLUX SA
25, Salzbaach L-9559 Wiltz
Tel : +352 26 81 54 1 • Fax : +352 81 05 17
www.codipro.net • [email protected]
SAFETY INSTRUCTIONS
About the accessory
Before using the accessory, it is essential for the safety and efficiency of use to read this instruction manual and to comply with all its
requirements. This instruction manual must be kept at the disposal of all users.
Read and keep legible the markings on the accessory. Make sure that the user to whom you entrust the accessory is trained and able
to assume the safety requirements involved in its use.
Respect a safety perimeter of at least 1 meter for any other person in the work environment. Protect the unit from uncontrolled
intervention when it is not in use. The manufacturer declines all responsibility for the consequences of disassembly of the accessory
and modifications made beyond its control.
When the device is in an obsolete condition that could cause risks, the user is obliged to neutralize the accessory, i.e. to put it out of
operation and possibly disassemble it.
About the handling
The equipment is not designed for lifting people. It is not permitted to pass under a suspended load and/or to expose personnel in
the handling area.
Do not exceed the rated load or lift loads not mentioned in the instruction manual. Do not use a damaged or malfunctioning unit or
one with missing parts.
Do not leave suspended loads unattended. Do not remove or cover warning labels. Do not operate the equipment without reading
and understanding the instruction manual.
Stay away from suspended loads. Do not lift loads higher than necessary. Do not make any repairs, alterations or modifications to the
accessory.
Use authorized parts with the accessory only. Follow the entire maintenance program described in this manual.
The operator must be adequately qualified to operate the accessory. Check the accessory before each use, as described in this
manual.
During handling, avoid all dangerous operations: shocks, jolts, vibrations, ...
All lifting accessories in contact with the rings must be dimensioned in relation to the rings and comply with the applicable standards.
The thread (diameter and/or length) must be appropriate for the material into which it will be screwed. The threaded hole must be
clean, conform to the applicable standards and of sufficient length to fit the entire bolt.
CONDITIONS OF USE
The lifting ring is designed to be mounted in a compatible threaded hole, conform to the standards in force, on a part allowing the
base to be completely supported on it and allowing the moving parts to articulate without obstacles to movement.
Risk of unscrewing: It is imperative to tighten the lifting ring to the torque indicated on the equipment, using a
torque wrench for any application involving rotation of the shackle. In the case of manual tightening, it is the user’s
responsibility to ensure that the shackle is correctly tightened and that the base plate is fully supported on the load.
During the lifting process and in all cases, it is necessary to visually check the correct support of the base plate.
RECEPTION OF THE MATERIAL
The material is delivered with an instruction manual and a CE declaration
of conformity. Make sure that the equipment is complete and that no
components are missing. To do so, refer to the description of the accessory
above.
ASSEMBLY AND COMMISSIONING
The material is delivered assembled. It is the user’s responsibility to check
the suitability of the product for the workstation.
Commissioning is the responsibility of the user company. It is therefore the
user’s responsibility to carry out the steps and controls according to the
standards and regulations in force at the place of use.
DESCRIPTION OF THE ACCESSORY
Overview