7
3
Microphone
Antenna
External single speaker
(3.5mm Mono Out)
External Dual Speakers
(3.5mm Stereo Out)
Initial Installation
After installing your antenna, ensure that you have the best possible
SWR reading.
By using the optional separation kit EDS-28, you can use the front
panel and the main unit in separate positions. The instruction
manual for remote placement is provided with the EDS-28.
IMPORTANT: RF Hazard Warning
The electro-magnetic exposure of this device may exceed the European
standards of the hazard level when transmitting at the high-power
setting while connected to a unity gain antenna at a distance of 63cm
or less from the operator. Furthermore, the hazardous RF exposure
level depends on the conditions of the combination of the antenna gain,
distance from the operator, output setting and installation environment,
therefore the operator may be exposed to stronger RF even at a
distance of more than 63cm. For safety purpose, it is recommended
that the antenna be installed outside of, and as far as possible from,
the operator’s area. Avoid using an excessively high-gained antenna in
case the distance between the operator and the antenna is very limited.
Always use the minimum necessary output power for communications.
The main unit can be set with either side facing up. This can facilitate your
ability to hear the speaker clearly. Position the front panel as you prefer.
Slide the front panel while keeping the tab pressed.
11
Front Panel separation
Slide the front panel until it locks securily in place.
41
Turn the front panel, being careful to keep the cable free from kinks.
21
Match the catch in the main unit with the slot in the front panel and
31
fit the front panel into the main unit.
Front panel
Main unit
Tab
Slot
Catch
