www.KDEDirect.com
TREX 700 NITRO ELECTRONIC CONVERSION KIT
INSTALLATION INSTRUCTIONS
Install the M3 x 0.5 x 8 mm Socket Button Head Collar Screws to the blue-highlighted
locations.
Install the M3 Flat Washer and M3 x 0.5 Locknut to the red-highlighted location, which will
secure the frame to the original carbon braces.
`
PARTS REQUIRED:
M3 x 0.5 x 8 mm Socket Button Head Collar Screws (included in original T700N kit)
M3 Flat Washers (supplied with kit)
M3 x 0.5 Locknuts (supplied with kit)
M4 x 0.7 x 20 mm Socket Head Cap Screws (supplied with kit)
M4 Wide Flat Washers (included in original T700N kit)
M4 Flat Washers (supplied with kit)
Install the original Tail Boom Brace to the green-highlighted location with the
following fasteners in sequential order:
1. M4 x 0.7 x 20 mm Socket Head Cap Screw
2. M4 Wide Flat Washer
3. Tail Boom Brace Plastic Mount
4. M4 Flat Washer (x2, double-stacked for ~2.0 mm spacing)
5. Carbon Fiber Frame Brace
6. Carbon Fiber Main Frame
7. Aluminum Bottom Bracket Upgrade (rear M4 tapped hole location)
