Alienware Area-51 R3 Threadripper Edition, Service Manual

Page: 53 / 199

Replacing the right AlienFX side-
panel connector
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer . After working inside your
computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance .
Procedure
1 Route the cable through the slot on the bracket and align the screw holes on
the right AlienFX side-panel connector with the screw holes on the bracket.
2 Replace the two screws (#6-32x6) that secure the right AlienFX side-panel
connector to the bracket.
3 Align the screw hole on the right AlienFX side-panel connector assembly
with the screw hole on the chassis.
4 Replace the screw (#6-32x6) that secures the right AlienFX side-panel
connector assembly to the chassis.
5 Connect the cable that connects the right AlienFX side-panel connector to
the I/O board. See “
I/O-board components ”.
Post-requisites
1 Replace the left and right side-panels. See “ Replacing the side panels ”.
2 Replace the stability foot .
53