3
2.Please do not see the laser beam directly to avoid any damage.
3.Before connect or disconnect the power, please adjust the luminance of the
laser diode to the least to avoid any damage to the laser diode.
4.This unit should be keep dry, do not use in the rain and dusty environment. It
can be use in the outdoor with the water-proof cover protector.
5. Set the light immobility and try to avoid strong shake or hit.
6.Prevent dust into the equipment to avoid problems.
7.Please keep that there's no other equipment or decorating materials
obstructed the exhaust fan and the vent-pipe when the equipment was
working.
8.Before connect power, check the plug is immobility or not, power line should
be connect well.
9.Please do not open or close the equipment frequently that's to avoid any
affect to the life span of the laser diode, and try the best to avoid the long time
working.
10.Due to the characteristic of the laser diode, after four hours working, it
should be close at least 25 minutes until the laser diode cooling then work
again.
11.Don't touch the light or draw the power line when your hand was wet. And
do not pull the electronic power line.
12.Maintain the distance at least 3M above from the equipment to the object.
13.This equipment does not have any parts can repair for the users, please do
not open the equipment.
14.When the laser diode became dim or damaged please contact the dealer
timely.
15.When you want to retransfer the products,you'd better use the original
package to shockproof.
Function Instructions
1. When dip switch No.10 is set to the "ON "position, the unit works in auto
mode.
2. When all dip switches are set to the "OFF" position, the unit works in sound
-active mode.
3. Auto-play(Master-slave synchronization)
：
when master laser dip switch
setting to No.10
，
the light will run the settled program automatically,
meanwhile, it will have DMX512 signal's output ; Just one light could be settled
to be master. Setting slave
：
you should put dip switch No.1 in "on"
4.Sound active(Master-slave synchronization)
：
when all dip switches are
turned off
，
the light is in sound-active mode. In this condition, the light will run
program along with music
，
meanwhile, it will have DMX512 signal's output.
Just one light could be settled to be master. Setting slave
：
you should put dip
switch No.1 in "on".
5.Address code function mode setting