4
2.The way of parking
①
Attention when parking vehicles and pedestrians around, slowly to the dock flat road on
the right side, avoid parked on the ramp.
②
After the car stopped, lock a right-handed and pull off the power supply, then use locks
to lock.
3. The power indicator method of use
Turning on the power supply voltage indicator, full electric LOW \ HALF \ HIGH 3 Led-
lights, HIGH lights that electricity used up 75% of the rated capacity, HALF lights charge
25% of the rated capacity, LOW lights flashing indicates that power is less than 10%;So
when you find LOW lights flashing charging immediately.
4. The use of the power lock
Power lock key clockwise rotation through a gear, can start the motor., not the keys and
shut off the power, more can't counterclockwise shut off the power locks, to cut off the
power supply motor stalling. Turn off the power supply after parking, power locks shall be
counterclockwise, pull out the key.
5. Hand tube(speed)
Rotate in the direction of the driver is accelerated, relax rotary reduction, power of motor
stops after a reset.
6. The use of the disc brake method and matters needing attention
(1) The use of the disc brake
①
The brake clearance adjustment: turn the adjusting nut by 2 mm Allen wrench
(between the brake lever and handlebar tube), adjust the gap of between disk and pads,
until you feel comfortable position is advisable.
②
The brake pads wear every six months, more than 1 mm or brake linings on the handle
of the location of the adjusting nut has to adjust, you need to change the time; Replace
the brake pads, with a clean bottle with a screwdriver to press the one piece of brake
pads into, with empty space to take out another piece, after replacement of the new
brake pads, need to put the brake on the brake lever adjusting screw back into the right
position (you feel comfortable position).
③
Period: It takes time, on the surface of the disc brake break-in to completely after
running-in, braking force will increase obviously. New brake used in the first week period,
the period not to crush the brake, it would have been on ontology and pads.
7, The use of the charger
(1) Method of use
①
When charging, first insert the battery box, and then plugged into mains AC220V plug,
charging end, on the other hand, the
first grid AC220V plug, pull out the battery box plug again.
②
Normal charging, charging indicator light shows red, full of, the charge indicator shows
green.
③
If the temperature of the charge temperature, a red light flashing, the charger is in a
state of temperature protection, please put
the charger moved to a cool and ventilated place to use, when the internal temperature of
the charger to charging 60°back to normal.
8, Use method and matters needing attention of the battery
Summary of Contents for Alien Beast
Page 1: ...N1 MANUAL ...
