Alien Flier Zip Series, Installation & Owner'S Manual

Page: 18 / 29

18
Copyright
©
2012 Alien Flier LLC. All Rights Reserved
Setting up a Zip Line with Turnbuckle Tensioner
All Explorer T, TD and S models
Required Tools:
leather gloves, wrenches for tightening clamps and turnbuckle
1. Select the location for your line. Only use trees that are about 8+ inches in diameter
(hardwood trees are recommended)
2. Be sure that there are no obstructions, electrical wires, ravines, roads, etc. in the
way.
3. Determine distance to be sure that your line will fit between your trees.
4. Wrap one end around tree and thru loop, approximately 8-12 ft up the tree.
5. Thread line thru the trolley.
6. Move to the next tree.
7. Wrap the sling (cable with loop at each end) around the tree approximately 6-8ft
high.
8. With the turnbuckle fully extended, attach it to the sling.
9. Attach the end of the line to the turnbuckle using the clamps provided
(
see illustration on page 4 for correct clamp installation )
10. Using the wrench, tighten turnbuckle until there is no slack in the line.
SAFETY NOTES
We highly recommend the following:

Install a Stop Block at the termination point of all zip lines.

Install a Safety Link from the lower tree to the looped end of the cable.