3
www.observint.com
© 2019 Observint Technologies. All rights reserved.
9.
Apply power to the camera.
10. Open the DVR Live View screen.
Step 3. Select the video format
You can set the video format of the camera to either TVI, AHD, CVI, or CVBS. The video format currently
selected usually appears in the upper left corner of the Live View screen. The format you select must be
compatible with your DVR or monitoring device. To change the format to another option:
1.
Find the tag on the video drop cable for the latest instructions.
2.
Unscrew the cap on the button switch. See the drop cable photo on page 1.
3.
Press and hold switch button for 5 seconds to change the video format to the next format in the
rotation shown on the tag. Repeat this step until the format you prefer appears on the Live View
screen.
4.
Screw the cap back onto the button switch drop cable. Ensure that the cap is tight.
5.
If installing the camera onto a junction box, secure the junction box front plate with the camera to
the junction box.
Step 4. Adjust camera pan, tilt and rotation
Adjust the camera pan, tilt and rotation to point the camera at your surveillance target. When pointing the
camera, observe the
Live View
display on a recorder or remote login.
Camera adjustments
1.
Loosen the lock nut.
Lock nut
Pan adjustment: 0° ~ 360°
Tilt
adjustment
0° ~ 180°
Rotation lock screw
2.
While observing video from the camera, point the camera at the center of your surveillance target.
3.
Tighten the lock nut.
4.
Rotation adjustment
: If necessary, loosen the rotation lock screw, and then rotate the camera
body to produce a good horizontal alignment of the image. The rotation adjustment range is
0° ~ 360°
.
Tighten the rotation lock screw.
Step 5. Enable Strobe and Siren feature
The special strobe and siren features of this camera are disabled by default. To use these features, they
must be enabled. You can also setup a weekday schedule for when this feature is used. In the example
below, this feature is enabled through the recorder console. To use the feature:
1.
Log into the recorder console as a user with administrative privileges.
2.
Open the Motion Detection menu. Go to
Menu | Camera | Event | Normal Event | Motion
Detection
.
False Alarm Filter select box
3.
On the camera line, open the drop-down list and select the camera you want to configure. In the
example above, the camera connected to channel A1 was selected.
4.
Check the
Enable
box for
Motion Detection
. Refer to the camera firmware user manual for
procedures to configure the motion detection area, setup Motion Detection Alarming Schedule and
Linkage Actions.
5.
Check the enable box for
False Alarm Filter
(see above).
6.
In the popup
Note
window, click
OK
to continue.
7.
Click the
Set Lighting Plan
button.
8.
In the Arming Schedule that opens, select the times during the week when this feature is
continuously enabled.
a.
You can Continuous or None, and then drag a rectangle across the array to enable or disable
this feature at those times.
b.
Click
Apply
when finished.
NOTE
: Segments in the schedule array shown below indicate
that the feature is enabled. Refer to the firmware user manual for your recorder for more
information on setting the Arming Schedule, if necessary. You can also set the schedule using
the Edit feature (see below) and copying that schedule to other cameras.
9.
After clicking
OK
or
Apply
to save the schedule settings, return to the Motion Detection menu.
10. Click Apply to save your configuration.
