13
ALI-NP7012RT IP PTZ Camera Installation Guide
Network (LAN) cable
Connect the network LAN drop cable to a router (switch) through an Ethernet drop cable with an RJ-45 connector. If the drop cable
RJ-45 connector is exposed to moisture or dust, apply the Ethernet drop cable seal kit provided. In some network configurations,
the LAN cable can connect directly to a Network Video Recorder (NVR) with a built-in network switch.
Power cables
You can power the camera directly by applying 24 Vac power to the drop cable power screw-down connectors. Refer to
“APPENDIX D 24 Vac Wire Gauge and Transmission Distance” on page 31 for more information.
The LAN cable can also provide Hi-PoE to the camera. A Hi-PoE injector is provided. A typical PoE injector is shown below.
Injector status LEDs
LAN cables for
DATA IN (to network switch) and
DATA and POWER OUT (to camera)
Ground wire
Port labeling
To use the injector:
1. Connect the injector ground wire to an earth ground terminal. (
NOTE
: Not all PoE injectors have a ground wire.)
2. Connect a LAN drop cable between the network switch and the DATA IN port on the injector.
3. Connect a LAN drop cable between the injector DATA and POWER OUT port and the camera LAN drop cable.
4. Plug the power cable provided (not shown) for the PoE injector into the jack on the injector, then into a standard 120 Vac
electrical outlet.
After power is applied to the camera, the camera will perform initial motion checks. Allow these motion checks to complete before
continuing (~ 1 minute).
SECTION 2: INSTALLATION
Summary of Contents for ALI-NP7012RT
Page 6: ...vi NOTES ...
