13
ALI-IPZ5030 Series IP PTZ Camera Installation Guide
2.4 Ceiling mounting
Following the instructions below to install the camera using the
ALI-PTCL Ceiling Mount Bracket
.
1. Determine the best mounting screws and hardware to anchor the mounting bracket with the camera to the mounting surface.
Use the following guidelines:
—
For cement ceiling mounting, use the expansion screw to anchor the bracket.
—
For wooden ceiling mounting, use self-tapping screw to anchor the bracket.
—
Make sure that the ceiling is strong enough to withstand more than
8 times
the weight of the camera and the bracket.
2. Using the mounting bracket as a template, mark the location of the mounting screw holes on the ceiling.
3. If the camera drop cable will be routed through the ceiling, mark the location of a hole for the camera drop cable. The drop
cable will be routed through the mounting bracket and can be routed either through the mounting surface or out the side of
the mounting bracket.
4. Drill holes in the mounting screws and hardware. Also, drill a 1½" diameter hole in the mounting surface for the drop cable.
5. Clip one end of the safety cable to the tab on the top of the camera assembly.
6. Route the camera drop cable through the mounting bracket, then clip the safety cable onto the loop in the mounting bracket.
Pendant adapter
Ceiling
Coupling
Drop cable
Safety cable
Align
marks
Back box
Lock screw
7. Fit the camera coupling into the ceiling mounting bracket, then twist the bracket to align the marks on the bracket and the
camera back box. See the figure above.
8. Tighten the two lock screws on the ceiling bracket to secure the camera to the mounting bracket.
9. Feed the camera drop cable through hole drilled at the mounting location, then anchor the mounting bracket to the ceiling.
SECTION 2: INSTALLATION
Summary of Contents for ALI-IPZ5030RT
Page 6: ...vi TABLE OF CONTENTS...
