Moffat Service
1800 622 216
Parts
1800 337 963
Washtech XM
1803
Distributed in Australia by
Power Button
Wash Temperature
Cycle Selector
Rinse Temperature
Cycle Light
Drain Button
XM
START
•
Turn on at wall
•
Ensure the Filter (1) is locked firmly in place
•
Check the Upstand (2) is in place
•
Shut door and turn Cycle Selector to I, II or III
•
Power light glows red and the machine will fill automatically
OPERATION
•
Select cycle of 1
(
I
)
, 2
(
II
)
, or 3
(
III
)
minutes
•
Load rack into machine and shut door
•
Cycle light glows green while machine operates
•
When the Cycle light goes out, the cycle is complete
NOTE: The machine may be started once the Wash light glows amber and the Rinse Ready light is off,
however it will continue to run the wash cycle until the rinse water is up to temperature
SHUT DOWN - EVERY NIGHT
•
Remove Upstand (2) only
•
Press Drain button to drain wash tank
•
Press Drain button off when tank is empty
•
Turn Cycle Selector to 0 and turn off the power from the wall
•
Clean the tank then remove and rinse Filter (1) before replacing
back in machine with Upstand (2)
•
Ensure Filter (1) is pressed firmly down and has clicked into place
CLEANING – AT LEAST ONCE A WEEK
Remove, rinse and replace:
Filter
1
Upstand
2
Wash/Rinse Arm
3
Inspect and clear all jets in the upper and lower
Wash/Rinse Arms using a small object such as a
toothpick where necessary to remove any
blockages prior to rinsing
SUGGESTED BEST PRACTICE
Cutlery
Stack with handles or sharp blades down and avoid overloading
Pre-rinse
Scrape and/or rinse plates & glasses in cool water
Chemical
Use good quality non foaming commercial detergent and drying agent – do not use
domestic detergent which will cause the machine to foam
Wash results
If wash results are deteriorating, check that you have haven’t run out of detergent
and that the wash/rinse arms are clean and free of obstructions
Draining
Use the Drain button to lower the water level before removing the Upstand
