Step 1: Place wood legs (L) on a hard
level surface approximately 48 inches
apart (as in figure 1) with the beveled
cutout facing up, and towards each
other.
Figure 1
Step 2: Place one wood base support (K) onto wood
legs (as in Figure 2). (The ends of the base support
should be arching up and the countersunk holes on
the sides of the base support to the outside). Line up
the hole on the top of the base support with the hole
in the beveled part of the legs. Place a washer (C)
onto one of the 5.5” bolts (B) and insert bolt down
through the wood base support and wood leg. Place
another washer (C) onto end of bolt and a lock nut (D).
Loosely tighten bolt and nut using the 2 piece
wrenches supplied. (
Only loosely tighten at this time
to help with aligning holes. Securely tighten when all
pieces are successfully assembled)
Repeat the
procedure with the second leg and with the second
base support (K) (as in Figure 3).
(L)
(L)
(K)
Figure 2
Figure 3
Figure 4a
Figure 4b
Step 3: Locate wood upright support (J) and place end
with the two side holes between the base supports (as
shown in Figure 4a). Place a washer (C) onto one of
the 9.5” bolts (A). Place bolt with washer through the
wood base support, through the upright support, and
through the opposite base support. Place another
washer (C) onto end of the bolt along with a lock nut
(D). Loosely tighten using the 2 piece wrenches.
Align second hole and repeat above
procedure (as shown in Figure 4b.)
Repeat entire step with the second
upright support on the opposite end.
