5006 Centrex AuxBox
DC5006UG-02 4
Installation
Connecting the 5006 Centrex AuxBox to your Centrex telephone
1. Disconnect your telephone line cord from the wall jack and connect to either
one of the RJ12 telephone jacks on the 5006 Centrex AuxBox. Using the
supplied telephone line cord, connect the second RJ12 telephone jack on the
AuxBox to your telephone wall jack.
2. Ensure that your Centrex telephone is operational. This may take a few
minutes depending on your telephone system.
- OR -
3. The 5006 may be installed in a bridging configuration using either RJ12 jack.
Maximum recommended cord length is 15 feet.
Connecting to your PC USB Port
1. Connect the USB cable to your PC and to the 5006 Centrex AuxBox.
Connect the power supply to the 5006 Centrex AuxBox.
The first time you connect the 5006 Centrex AuxBox, Windows should advise
“New hardware Found”
and proceed to load the necessary drivers. Windows
should install up to 3 sets of drivers:
USB Composite Device, USB Audio
Device, and Human Interface Device (HID).
2. For each, select the recommended driver by clicking the
Next
and
Finish
buttons as appropriate. You may be prompted for your Windows CD during
this process. Note that on many computers these files are also stored in
C:\WINDOWS\OPTIONS\CABS.
Ask your System Administrator if you have
any difficulties.
The lights on the front panel indicate whether the hardware installation was
successful. The Power/USB light will be winking to indicate communication with
the PC USB port.
Lift the telephone handset (or go off-hook with the speakerphone or headset) to
turn on the “IN-USE” light on the front panel of the 5006 Centrex AuxBox. This
indicates that the unit is working properly.
Please refer to the Client Call Recorder User Guide for software installation
instructions.
