Alfresco URS-1XE, Care And Use Manual

Page: 5 / 10

LIGHT BULB LOCATION:
TROUBLESHOOTING
BEFORE CALLING FOR SERVICE
If the unit does not function properly use the following checklist before contacting your dealer for service. You may
save the cost of a service call and the inconvenience of being without your refrigerator.
REFRIGERATOR NOT COOLING ENOUGH
Lower the temperature of the cabinet by adjusting the digital thermostat to a lower setting.
NOISY OPERATION
This is usually caused by the unit not being level. Reposition the refrigerator to see if the noise can be eliminated.
MOISTURE ON OR IN UNIT
Warm moist air will condense on cold surfaces. Condensation inside the unit can be caused by too frequent or
prolonged opening of the doors. Moisture can also be caused by the thermostat being set too cold. Check the
temperature of the unit. Try adjusting to a slightly higher temperature to see if the problem can be eliminated.
Minimize door openings and verify that the door gasket is sealing properly around the perimeter.
APPLIANCE RUNS TOO LONG
Running time will change with outside temperature, number of times and length-of-time the doors are open, etc.
This is normal in hot or humid weather and is not detrimental to the operation of the unit
LOCATING AND INSTALLING YOUR REFRIGERATOR
NEVER SPLASH OR SPRAY WATER FROM A HOSE DIRECTLY ON THE REFRIGERATOR. DO NOT LOCATE THE
UNIT WHERE IT WILL BE SUBJECT TO DIRECT SPRINKLER SPRAY. EXCESSIVE WATER CONTACT MAY RESULT
IN ELECTRICAL SHOCK, SERIOUS INJURY OR DEATH.
SELECT LOCATION
The proper location will ensure peak performance of your refrigerator. Choose a location where the unit will be out of direct
sunlight and away from heat sources. Your
ALFRESCO refrigerator is designed to be operated in a properly ventilated
area with an ambient temperature of not less than 30°F, nor more than 120°F.
Your ALFRESCO refrigerator requires ventilation from the bottom front of the unit. For a cart-mounted (Optional wheel
kit) model, keep the area directly in front and behind the unit clear of obstructions. For a built-in unit, make sure the back
and bottom of the unit have at least 2 inches of clearance to the cabinet, and that the unit can be easily removed from
the cabinet for servicing.
ELECTRICAL SERVICE
All ETL listed refrigerators are equipped with a three pronged plug. Use only the electrical cord supplied with the unit,
which must be plugged directly into a properly grounded 3-pronged outlet, preferably a GFCI circuit, in accordance with
the National Electrical Code and applicable local codes and ordinances. The third prong (grounding prong) SHOULD
NOT, under any circumstances, be cut or removed. Do not use an extension cord with this unit.
LIGHT BULB AND
SWITCH HOUSING
LIGHT BULB LOCATED
BEHIND SWITCH HOUSING