2
ALFRA lamination punching and cutting unit
Performance data
Area of use:
-
Cutting and perforating laminated copper and aluminium busbars
-
Cutting thicknesses:
max. 10 mm
-
Perforation range:
Through-holes for screws M6
– M14
-
Dimensions H x W x D: 380 x 350 x 150
Pressure generation:
-
As the drive unit, we recommend our foot pump Prod.-No. 02121 or our electro-hydraulic
pump DSP 120 Prod.-No. 02027
General description an operating instructions for the laminated punching and cutting
unit, complete version
Configuration:
Work unit
Lamination punching / cutting unit, consisting of:
Basic unit, cutting block, hole-punching tool (die and die plate)
Basic units
For holding:
Cutting block
Hole-punching tools
The pressure unit, consisting of the hydraulic piston and cylinder (including the die holder in the upper
section) is permanently integrated into the basic unit.
The lower section contains the central locating hole for the die plate and cutting block insert.
Stops are also fitted at the front and sides for perforation in the unit. For self-assembly, the retaining
rods must be fitted centrally in the base plate into the threaded holes provided for that purpose. For
this, fit the long stop on the narrow side and the short stop on the wide side of the base plate.
Cutting block
Cutting unit for waste-free cutting through of aluminium or copper rails.
Assembly:
-
Fitting the stop into the bottom plate of the cutting block (screw in and lock in the threaded hole
provided).
-
Insert the cutting block into the locating hole of the basic unit.
When doing this, ensure that it engages correctly into the centring pin.
-
Brace on the right and left against the upper section using knurled nuts.
Pressing is always with the piston without a union nut
Summary of Contents for 03300
Page 4: ...4 Basic unit Prod No 03300 ...
