Alf micatronic H19EN, User Manual

Page: 32 / 40

30
5. SAFETY FUNCTIONS
5.1. Tip Over Protection
5.2. Safety Distance Sensor (For Only Remote Control Model H23EN)
ALF MICATRONIC, has “Tip Over Protection” system to prevent the risk of fire in case of heater
is tipped over. This function works differently in “Remote Control Model” and “Thermostat
Model”.
“Remote Control Model” warns with a three long “beep” signal and “Er” warning on the
screen, when it is tipped over more than 30° angle. After these audible and visual warnings,
it returns back to stand by mode “H0”. Press the On/Off button in order to activate the heater
again.
“Thermostat Control Model” switches off when tipped over more than 40° angle and
switches on when returned back to correct operation position.
CAUTION!
This is an additional safety function. It does not prevent you against risks
such as injury and fire, by itself. Please read “Safety Precautions” section at the top
of this manual carefully.
ALF MICATRONIC, is equipped with a sensor which detects the objects in front of the
command panel. This sensor reacts differently for 2 different case;
1. If the distance of the object detected by the sensor and the control panel, is between
~1 m to ~20 cm. (This distance may vary according to the shape and color of the
objects),then it lowers the heating power to a minimum level automatically. In this case,
heater will react in a short time, when object is detected.
2. If the distance of the object detected by sensor and control panel is lower than 20 cm.,
after ~7 seconds, heater warns you with a 3 long “beep” signal and “Er” error on control
panel. Then it returns back to stand by mode “H0”. Press On/Off button to reactivate the
heater again.
WARNING!
“Safety Distance Sensor” do not work when objects are as close as to a
touching distance.
ALF_MIKA_TOWER_KK_140813.indd 30 27.09.2013 18:08