Alesis QuadraSynth, Reference Manual

Page: 111 / 134

Editing Effects
110 QuadraSynth Reference Manual
Mix
Not to be confused with an actual or Mix mode, the EffectÕs Mix function is where
you can mix the various signal levels of all the effects to the Main Left and Right
outputs of the QuadraSynth. Only effect modules that have access to the Main
outputs will appear on the Mix page. There is a separate Mix page for each of the
four effect busses whose effect modules feed the main output. Note that the Mix page
doesn't control how much the individual effect modules feed to each other; only how
much they feed to the Main outputs.
PROG EFFECT
PRESET
EDITING: EFFECT
PITCH MOD NAME
CONFIG REVERB DELAY MIX
PAGE: 1
DELAY OUTPUT: 50
DELAY PITCH REVERB
PRESET
MIDI
CHAN
MIX
PRESET
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1
Depending on the selected Configuration, the order of the effects will differ (for
example: in Configuration #1, the order reads Pitch, Delay, Reverb; but in
Configuration #2, the order is Delay, Pitch, Reverb).
Pitch Level
Adjusting this value will cause the Pitch Output Level to increase or decrease. The
Pitch Output level is the level for the Pitch Section of the QuadraSynthÕs effects
processor to the Main outputs, and should be set as desired.
Even if this parameter is set to 00, the output of the Pitch section is still available
(depending on the bus and configuration) to following Delay and Reverb sections.
Delay Level
Adjusting this value will cause the Delay Output Level to increase or decrease. The
Delay Output level is the level for the Delay Section of the QuadraSynthÕs effects
processor to the Main outputs, and should be set as desired.
Even if this parameter is set to 00, the output of the Delay section is still available
(depending on the bus and configuration) to following Pitch and Reverb sections.
Reverb Level
Adjusting this value will cause the Reverb Output Level to increase or decrease. The
Reverb Output level is the level for the Reverb Section of the QuadraSynthÕs effects
processor to the main outputs, and should be set as desired.