www.aleratec.com
5
Unpacking the Unit
Your system was shipped in one box and contains the 1:3 DVD/CD LightScribe
Duplicator SA and cables.
Carefully open the box and remove the top protective foam padding. Remove the
following:
•
1:3 DVD/CD LightScribe Duplicator SA
•
1 Power Cord
•
1 USB 2.0 Cable
•
1 Quick Start Guide
•
1 Nero Software CD
•
2 Hard Drive Tray Keys
•
1 Installation CD
Note:
It is important to keep the original shipping container and
packaging. In the event you misplace your packaging and need
to ship the 1:3 DVD/CD LightScribe Duplicator SA, you should first
contact technical support to purchase a new shipping container.
Shipping the 1:3 DVD/CD LightScribe Duplicator SA without proper
packaging will void your warranty.
Connect the Cables and Apply Power
Plug the power cord into the power supplys of the 1:3 DVD/CD LightScribe
Duplicator SA, also located on the rear side (make sure the red switch is set at 115
VAC). Plug into a standard 115 VAC outlet.
Plug the USB 2.0 Cable into the USB connector located on the center rear of the 1:3
DVD/CD LightScribe Duplicator SA. Connect the other end of the USB cable into
an available USB 2.0 port on your PC.
Note:
Use only with a USB 2.0 port. This system cannot be used with
USB 1.1, as this will greatly affect system performance. If windows
displays a message that a fast USB device is detected on a slow USB
port, then you will need to upgrade your computer by adding a USB 2.0
port.
