Pump Hoist and Power Ram
SER 7818-F5
Alemite Corporation
15
Revision (6-04)
Follower Plate
Assembly
Hoses to Follower Plate
NOTE: Refer to Figure 2-E for component
identification on the following procedures.
1. Insert Clamp (81) into upper Hose (83).
IMPORTANT: Hose (83) is slightly longer
than lower Hose (82).
2. Coil the Hose assembly into the upper groove of
Follower Plate (78).
HINT: Position the Follower Plate assembly
on its outer circumference with the Clamp
opening upward.
Changes Since Last Printing
Deleted Pump Models 7785-B5 and 7786-C from Table 1
3. Draw the Clamp tight against the Hose and Follower
Plate.
4. Close the opening in the Hose.
• Hammer the Hose with a wooden or rubber mallet.
• Make sure the ends butt squarely.
5. Repeat steps 1 through 4 for lower Hose (82).
IMPORTANT: Make sure the opening on the
Lower Hose is 180 ° opposite the upper
Hose.
1-800-548-1191-http://[email protected]
