16
35
6
5
M6 BOLT 32mm (x4)
16
6
6
16
F5
F5
F3
F3
F3
(x4)
(x4)
M6 BOLT 60mm (X4)
F6
5
35
5
35
F6
F6
M8 BOLT 59mm (X1)
M6 BOLT 52mm (X12)
M8 BOLT 65mm (X4)
F5
43
Nest Swing & Glider - BSW08
Anchoring Swing Set to the Ground
Step 1.
Attach Ground Pegs to all 4 Nest Swing Bottom Legs using F6 fasteners.
Step 2.
Place assembled Swing Set in desired location and dig a footing hole,
measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each
support leg.
Step 3.
Prepare and pour concrete into the footing holes following concrete
manufacturer's instructions. Fully fill footing holes to be level with ground surface.
Step 4.
While Concrete is still wet,
a
ngle Ground Pegs toward
opposing legs
at roughly
120-degrees, then insert Ground Pegs into concrete footing, making sure Swing
S
et
Bottom Legs do not sink below ground surface (utilize concrete set time information).
Use temporary support made from wood or other material if necessary to prevent
sink
ing
(Fig. 5)
.
Swing Set will be ready for use once concrete is fully set and cured (consult concrete
manufacturer's instructions).
visit us at www.aleko.com
Fig. 5
