33
About 15-20 minutes before the battery is empty, the ‘
’
button will flash on the display. A beep tone
will also sound every 60 seconds. Immediately plug in the adapter.
The adapter takes about 5 hours to charge up an empty battery.
6.6
INTERFERENCE FREE:
• This baby monitor is digitally encoded. You will never receive a signal from other equipment and
the signal from your baby unit (s) will not be shown on other parent units, for example, your neigh-
bours.
• In the event that the baby unit(s) or the parent unit is in or near the vicinity of electromagnetic
fields, the signal (video or audio) may be interfered or hindered. Try a different location for the
baby unit(s) or the parent unit, or if possible, remove the source of the problem.
6.7 RANGE:
•
The connection range of the baby monitor is up to 250 meters in an open field and 50 meters in a
house; the range can differ according to external conditions. Should the units go out of range from
each other, the image will first freeze (no movement) for a few seconds, followed by the “out of
range” message.
6.8
LISTEN IN/TAP IN:
• Eavesdropping/tapping into the baby monitor’s picture is virtually impossible. Not only does one
need to be in the range of the baby monitor, one would also need to have very expensive equip-
ment to make it possible.
6.9 MAINTENANCE:
• Only clean the baby monitor only with a damp cloth; never use chemical cleaning agents.
• Disconnect any power adapters before cleaning.
6.10 ENVIRONMENT AND DISPOSAL:
• The packaging of this baby monitor can be recycled as old paper. We recommend however that
you keep so that it can be packaged appropriately for transport.
• Old or damaged batteries should be disposed of in an environmentally friendly manner
according to your local regulations. Do no throw away used batteries together with your
household waste.
• Should the baby monitor need to be replaced, hand it over to your supplier; they will dispose
of it in an environmentally friendly manner.
6.11 IN CASE OF NO PICTURE, NO SOUND:
– Are the parent unit and the baby unit turned on? (adapters connected, battery full?)
– Is the parent unit within the range of the baby unit?
– Has the baby unit been switched off ? (VOX)
– Has the volume on the parent unit been switched to 0 (off)?
• If everything appears in order, take the power adapter out from the electrical wall outlet and remove
the rechargeable battery from the parent unit. Wait for a minute then put everything back. Turn the
parent unit and the baby unit on again.
• If you still have no picture or no sound, please contact the Alecto service department by phone 073
6411 355 (NL), 03 238 5666 (B), 0180 503 0085 (G) or via the website at: www.alecto.info
