2.3 CAMERA CONNECTION.
Use the supplied UTP cable to connect the camera to your internet router.
Connect the camera to the supplied adaptor and insert the adaptor (only for
indoor use) into a 230V mains wall socket.
It will now take 30 to 60 seconds for the camera to start-up. The camera will
indicate this by telling you what the status is in English.
As soon as the camera is properly registered on the router, start the AlectoCAM
app on your smartphone or tablet. Make sure that the camera and the
smartphone or tablet are connected to the same network. Keep in mind that
when using a router with 2.4 GHz and 5 GHz Wi-Fi, the smartphone or tablet
should be registered on the 2.4 GHz, otherwise the camera may not be detected.
This camera only works on 2.4 GHz.
Method 1:
Press + in the start screen of the AlectoCAM app to add a camera.
Now press LAN Search in the pop-up screen.
You’ll then see the UID code of the camera with the IP address. Select this UID
code or the correct code when multiple cameras are connected to the network.
The screen Add Device will open.
Now enter the password of the camera; the default password is “admin”, press
the OK check mark.
Please change this password after the camera is registered successfully.
The camera is registered successfully when the image appears. Now go the
camera settings and select Change Password to assign a unique password to
the camera. This is required for secure use of your camera.
