AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1300 889 028
24V Lithium-ion Cordless Drill with Hammer Action
MODEL: №.CDI224 • 09/2020 • 63524
25
Do I need to charge the battery before use?
Yes, new battery packs are shipped in a low charge condition and must be fully charged
before use. It takes approximately 3-5 hours to fully charge your new battery.
Follow the full section “Battery Charging “ in this manual on page 14-15.
Charging of Battery packs should not be undertaken casually. Through the charging cycle
the condition of the battery pack should be monitored and the charge cycle turned off at
completion or at the end of the recommended time.
How do I obtain the best life for the battery?
- Never allow the battery packs to run completely empty before recharging. The battery packs
should be placed on charge whenever the battery packs is noticeably running down or the
drill no longer performs a task it previously performed.
- Avoid allowing lose items like screws or nails etc. to be stored with battery packs as these or
similar items can short battery packs and cause a fire or explosion.
- Always unplug the plug pack charger when not in use and store in a dry secure place.
- Avoid charging or storing your battery packs in temperatures below 0ºC and above 45ºC.
How do I use the 2 gears on the drill?
To select the LOW gear (low speed, high torque setting), push the gear selector backward,
towards the back of the drill/driver. The number “1” will be displayed.
To select the HIGH gear (high speed, low torque setting), push the gear selector forward,
towards the chuck. The number “2” will be displayed.
NOTE:
The gears cannot be changed if the variable speed / on off trigger (8) is depressed.
How do I adjust the torque?
The torque function will only operate when the screw function (14) is selected by rotating the
function selection collar (3) and aligning the screw symbol with the triangular indicator on the
top of the drill.
To adjust the torque setting you rotate the torque setting / collar (2). The higher the number,
the higher the torque setting collar.
Controlling the torque allows for better control when using the drill/driver on specific add
screwing tasks and assists in preventing over-fastening and over-tightening.
For setting the torque position, first select a low setting on the torque setting / collar (2) and
align the selected symbol with the triangular indicator on the top of the drill/driver.
Slowly increase the torque setting to the desired level. It is suggested to test the setting on
scrap material first.
How do I select hammer function?
Rotate the function selection collar (3) until the hammer drill symbol aligns with the triangular
FAQ/Troubleshooting
