Understanding and using these operating instructions
750W Submersible Water Pump
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №.
WLBCF310 • 08/2015 • 49290
(toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: [email protected]
1800 909 909
MODEL: №.
WLBCF310 • 08/2015 • 49290
17
1. Prior to immersing the Pump, the float level cable needs to be set to
achieve the approximate water level range required. If the Pump is not
being immersed in water, the float level can be adjusted when the Pump
is located in position.
2. Locate the Pump in the operating position required, or immerse the
Pump into the body of water for your application. Prior to immersing
the Pump in water, ensure to connect the drain pipe to the outlet of the
Pump. If the Pump is not being immersed in water, connect the drain pipe
to the Pump after the Pump is located in the operating position. Where
the Pump is immersed in water, ensure the Pump is primed as per the
priming section of this manual.
If using in deep water, use a rope (not included) by securing it to the carry
handle (4). Place the Pump in the required position for operation. (Pic M)
3. To commence operation, insert the power plug into the mains power
supply and switch On. (Pic N). If the Pump has been immersed in water
and the float is lifting greater than 30° to the Pump, the Pump will start
and pump water. (Pic M)
4. To stop operation, turn Off the main power supply switch and the Pump
will stop. OR, if the Pump is left running, the Pump will stop after the
water level has reduced and the float is down approx 30° to the
horizontal. (Pic O).
If the switch is left in the On position, the Pump will start and stop under
the operation of the float switch. As the water level rises and reaches the
upper float limit, the Pump will start and drain the water down to the
lower float limit and turn off the Pump.
M.
N.
O.
