Cleaning
14
The heating rollers will automatically pull the laminating pouch in and move
it to the laminating pouch output slot
4
on the front of the laminator.
Don’t use force to pull out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
− If necessary, you can cut off excessive material after it has
cooled off.
− Repeat the process if the laminating pouch has not
adequately adhered to the document.
5. Move the ON / OFF switch to “
OFF
” ( ) to switch the laminator off.
Removing a jammed laminating pouch
The laminator is equipped with an antiblocking system. If the laminating pouch
was not inserted straight or it becomes jammed in the laminator, proceed as
follows:
1. Move the ABS switch
6
towards the laminating pouch infeed slot
2
and
hold it down (see
fig. C
).
2. Pull the laminating pouch
5
out of the laminator.
It is recommended you pull the laminating pouch out in the
direction of its larger end.
You can place the document in a new laminating pouch and laminate it again.
Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation. You may burn
yourself.
− Always let the laminator cool off completely before you
clean it.
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short
circuit.
Summary of Contents for OL 250-L
Page 4: ...4 A Ready O N O FF 2 1 4 5 3 ...
Page 5: ...5 C B B 6 3 ...