wire on the timer using a twist
connector.
b. Connect the remaining two
wires from the old switch to
the BLUE and RED wires on the
timer using twist connectors.
c. Connect the GREEN wire to the
grounding screw.
d. Use
Figure 1
to identify and
remove wire "C" from the
"Common" terminal of the
existing remote switch.
e. Use
Figure 2
to remove and
reconnect wires "B" and "C" to
the "Common" terminal of the
remote switch. Use the supplied
piece of jumper wire if needed.
the wall to the BLUE wire on
the timer.
NOTE:
The RED wire is not used
in a single-switch installation.
Cap with a twist connector.
c. Connect the GREEN wire on the
timer to the grounding screw in
the box.
d. Ensure all twist connectors are
tight.
3-WAY SWITCH SETUP
NOTE:
The distance between the timer and
the remote switch must not exceed 100 feet.
a. Locate the COMMON wire that
was connected to the old switch
and connect it to the BLACK
7- Day Programmable Timer
2
American ALDES Ventilation Corporation • 4521 19th Street Court East, Suite 104 • Bradenton, FL 34203 – USA
941.351.3441 • 800.255.7749 • 941.351.3442 (fax) • [email protected] • www.aldes.us
© 2016 American ALDES Ventilation Corporation. Reproduction or distribution, in whole or in part, of this document, in any form or by any means, without the express written consent of
American ALDES Ventilation Corporation, is strictly prohibited. The information contained within this document is subject to change without prior written notice.
7-day programmable timer_iom_1016
FIGURE 1
f. Follow
Figure 3
if a new single-
pole remote switch is being
used.
g. Place the wires into the timer
wall box.
h. Mount the back plate securely
to a wall box with the screws
provided in the parts package.
NOTE:
Make sure the back plate
is flat without any undue stress.
i. Re-install the front cover and
secure with the cover screw
supplied in the parts pack.
j. Follow steps
h
and
i
for the
remote 3-way switch.
OPERATION
Ensure that the installed timer displays
"MAN" mode on its display screen. Test
the connections by pressing the ON/
OFF button several times on the switch
timer. Each time this is done the timer
should "click" and the the controlled
device should turn on or off. To set or
rest the timer:
1. Hold down the ON/OFF button and
use a paperclip to press and release
the RESET button.
2. Continue to hold down the ON/
OFF button until
INIT
appears on
the screen.
3. Release ON/OFF.
The CR2 Lithium battery provides the
timer with two or more years of keeping
time without AC power. All personal
settings are saved in the timer once
installed, therefore, no resetting is
needed.
WARRANTY
1-year limited.
FIGURE 2
FIGURE 3
