ALDEN Skymatic, User Manual

Page: 10 / 16

ALD-06602 10
The following instructions are given as general advice: you MUST follow the instructions delivered with the
receiver that will be installed.
1. Place the receiver in a ventilated and accessible area.
2. Connect the receiver to the S.S.C.® unit (Out to demo).
Warning: Do not use the existing coax circuit. The quality of the picture could be altered. Each connection
between the satellite system and the S.S.C.® or between the S.S.C.® and the receiver can cause the signal to
weaken. Different types of cables can also cause interference.
3. Connect the television to the receiver.
4. Connect the receiver to the power supply. The + line must be protected with an adapted fuse (see the
instructions delivered with your receiver). We also advice to put a swith on the + line.
5. In the Setup menu of your receiver, make sure the local oscillator (LO) is at 10.7 GHz.
Warning:
• In any case, a direct line (no links) with an adapted fuse must go from the receiver to the battery for the
+ line.
• Always use the provided cables.
• The warranty will become void if these instructions are not followed.
Advice on how to install a receiver & cable connection
Coax cable
Motor cable
TV VCR / DECODER
DC
12... 18V in
5 A
FUSE
5 A
FUSE
+ after ignition
This supply must be able to deliver 1,5 A minimum
FUSIBLE 5A
+12V DC
Coax cable
Battery 12 V
RECEIVER / DECODER
Skew cable
More information https://www.caravansplus.com.au