ALD-13960
45
Warning
The reproduction of whole or part of this guide is strictly forbidden without Alden’s agreement.
Alden draws your attention to the risks that may occur if the mounting is not correct. Alden declines all responsability if the product is
not mounted in the correct way and especially if it is installed by a non professional person.
The retailer is ment to know installation rules and to apply them. He will especially respect the installation location, the cable
connection, the gluing and screwing. By selling and installing an Alden product, the retailer is obliged to inform his customer on how
the product works and perhaps how to install the product in some cases. He will also give the customer all relevent documents. The
retailer will inform the customer about security matters. The retailer must inform the end user on how to use an Alden product and
safety measures. The product is to be used only for the intended matter. The retailer must also inform the end user about the current
laws applicable in the country where the product is going to be used.
Each product with electronic components has to be protected from undervoltage (under 10,5 volts) and overvoltage (over 15 volts).
It is strictly forbidden to open, interfer, repair and/or modify the product without Aldens agreement. The warranty
will become void if you undertake such an action.
Neither the salesperson nor the manufacturer can be held for responsible if a satellite or a programme come to
disappear, if a free-to-air channel becomes scrambled or for any other modification that may affect the emission.
Unpredictable events can not lead to any exchange, refund or compensation from the salesperson nor the
manufacturer.The reception areas of the satellites are given as a guidance.
ALDEN declines all responsibility in the event of incidents or accidents if they are due to a non observation of the installation instructions
or the way the product is used.
Remove the fuse from the electric circuit board of the satellite system and receiver before interfering on the general circuit board, or
changing or connecting the battery. If the vehicle is equipped with a solar panel, also remove the fuse.
Keep away from children.
You must install separate cables, with a 5 Amp. fuse on the plus line, directly from the cell battery to the television.
Before interfering on the electric circuits, make sure the specifications of the device and the electric circuit are compatible.
For a good quality picture, do not use the existing coax cables. In general, it is best to avoid connections.
You must protect the ends of the motor and coaxial cables with paper tape during installation (especially when
threading the cables through furniture).
Do not drop or push objects into the television, the slots or the openings. Do not spill liquid on the television. Do not open or touch
the inner circuit. Do not remove the back cover: only a qualified professional is allowed to do so. Do not use the television if the power
supply cables or connections are damaged. Never lay anything on the cables. Make sure that the cables cannot be pulled off and that
no one will stumble over them. To unplug a cable, hold the plug and not the cable.
The openings are to ventilate the television. They have to stay free. Never lay the television on a bed, a sofa or any other soft surface.
This can block the openings and stop the television from being ventilated. If you install the television in a closed area, make sure the
ventilation is sufficient: there must remain a 20cm space round the television to assure a sufficient ventilation.
Do not expose the television to rain or water (kitchen, bathroom...). If this ever does happen, disconnect immediatly the power supply
from the television and contact your retailer.
Only use approved or the origial spare parts recommended by your dealer, if not, the warranty will become void.
Work on the unit must be performed by qualified technicians.