24
August 18, 2020
AES67 RECEIVER
In the AES67 Receiver you will need to fill the following settings
1.
Enable:
used to turn the receiver on or off.
2.
Stream Name:
This list will auto populate from the stations in your network that are sending an AES67
Stream. The stream name was set when you linked the station. Select the station’s audio that you want to
get on that receiver.
3.
Receiver Name:
This setting is done on the properties tab for the component. We recommend using a
name that can be easily related to the station that it belongs to.
4.
Interface:
Select which Q-Lan to use: Lan-A, Lan-B or Auto select.
At this point you should be able to see signal from your voice when you talk into the microphone while pressing
the push-to-talk button. Now you have audio going from the station to the Q-sys core so that it can be properly
routed for paging.