OmniAccess 4308: Installation Guide
4
Part 031638-00
May 2005
Serial Console port
This port is for connecting a local management console. It is required to access
the text-based Command-Line Interface (CLI) for initial configuration of the
Alcatel Wireless LAN Switch. The CLI can also be used for switch management
and troubleshooting.
The port accepts an RS-232 serial cable, an RJ-45 male connector. See
“Serial
Console Port”
on
page 25
for more port and cable specifications.
See the
Alcatel AOS-W User’s Guide
for information on using the features
available through this port.
Fans/heat exhaust (on side)
Three independent fans promote proper air circulation for cooling the Alcatel
Wireless LAN Switch.
During operation, the air vents on the left and right sides of the chassis must
remain unobstructed by cables or mounting equipment. For proper air
circulation, leave at least 10 cm (4 inches) of clearance on the left and right of
the chassis.
Holes for attaching rack mounting brackets (on side)
Power Input Socket (on back)
The power input socket on the back of the switch accepts a power cord with a
standard IEC320 connector. For proper safety and performance, the power
cord must be rated to 10 A and conform to grounded electrical standards in the
country where the product is operated.
The Alcatel OmniAccess 4304
The Alcatel OmniAccess 4304 is identical to the Alcatel OmniAccess 4308
except that it is licensed to support four Access Points only. All other features
and functions are the same as the Alcatel OmniAccess 4308.
The Alcatel OmniAccess 4304 software license can be upgraded to an Alcatel
OmniAccess 4308 and able to support up to 16 Access Points. For information
on upgrading the Alcatel OmniAccess 4304 to an Alcatel OmniAccess 4304,
contact your Alcatel sales representative to visit the support website.
4
5
6
7
