Alcatel-Lucent OmniAccess SafeGuard, Installation Manual

Page: 32 / 52

OmniAccess SafeGuard Controller Installation Guide
32
Chapter 2: Site Preparation and Installation
The insertion procedure for copper and fiber SFP modules is the same. To insert an SFP
module, follow these steps:
1 Put on the ESD-preventive wrist strap, and attach the leash to a grounded bare
metal surface on the SafeGuard Controller or equipment rack.
2 Identify the Tx and Rx marks on the top of the SFP module.
3 Align the module with the SFP module slot, and push it firmly into place until it
clicks into place and is completely seated (see
Figure 13 ).
Figure 13 Inserting an SFP Module
4 Check that the SFP module is completely seated by gently pulling on it to see if it
comes out of the slot.
Connecting Cables
Connect the front-panel ports using cables appropriate to the installed SFP modules:
■ Single-mode or multi-mode fiber cable with LC connectors
■
Category 5 or better copper cable with RJ-45 connectors
■ For Gigabit Ethernet connections, Category 5e copper cable with RJ-45 connectors
Connect the Ethernet management port using Category 5 or better cable with RJ-45
connectors, as shown in
Figure 14 .
CST_013