Alcatel-Lucent OmniAccess SafeGuard, Installation Manual

Page: 19 / 52

OmniAccess SafeGuard Controller Installation Guide
19
Chapter 1: Overview of the SafeGuard Controller
System and Port LEDs
The front panel of the SafeGuard Controller provides LEDS to indicate operating status of
the SafeGuard Controller system and ports (
Figure 6 ).
Figure 6 Front-Panel LEDs (OAG2400 Shown)
At the left side of the front panel are six LEDs and a push button labeled Mode. The top
three LEDs indicate power and alarm status for the SafeGuard Controller system; the
three lower LEDs are linked to the port LEDs and indicate the operating mode for one
port LED in each pair.
Each port has two associated LEDs. The upper LED is bicolor amber and green, and the
lower LED is green. The lower LED always indicates link status for the port. The upper
LED indicates one of three possible conditions, depending on which mode has been
selected using the Mode button at the upper left corner of the front panel. Pushing the
Mode button cycles through the modes and selects speed, duplex, or status as the
condition being indicated by the upper port LEDs.
Only one of the three port mode LEDs is on at any time. Pushing the Mode button cycles
through these three LEDs and changes the operating mode of the upper LEDs for the
ports. For example, when the Speed LED is on, the upper port LEDs indicate operating
speed for the ports. If you push the Mode button until the Status LED is on, the upper
port LEDs indicate the port protection mode.
NOTE: Not all SFP modules support 10/100 operation. To ensure guaranteed
operation of the system, obtain all SFP modules from Alcatel-Lucent.
CST_016
Mode button