Alcatel-Lucent OmniAccess 4504, Installation Manual, Page: 18 / 20

18 | Specifications, Safety & Compliance OmniAccess 4504, 4604, and 4704 WLAN Switch | Installation Guide
Storage Specifications
z
Storage Temperature Range: 0°C to 50°C (32°F to 122°F)
z
Storage Humidity Range: 5% - 95% (RH), non-condensing
Safety and Regulatory Compliance
Alcatel-Lucent provides a multi-language document containing country specific restrictions and
additional safety and regulatory information for all Alcatel-Lucent hardware products. The
Alcatel-
Lucent Safety and Regulatory Addendum can be viewed or downloaded from the following location:
https://service.esd.alcatel-lucent.com
.
This product complies with 21 CFR Chapter 1, Subchapter J, Part 1040.10, and IEC 60825-1: 1993,
A1: 1997, A2: 2001, IEC 60825-2: 2000.
For continued compliance with the above laser safety standards, only approved Class 1 modules from
our approved vendors should be installed in Alcatel-Lucent products.
FCC Class A Device
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Proper Disposal of Alcatel-Lucent Equipment
For the most current information on Global Environmental Compliance and Alcatel-Lucent products
please see our website at
www.alcatel-lucent.com
.
Waste of Electrical and Electronic Equipment
Alcatel-Lucent products at end of life are subject to separate collection and
treatment in the EU Member States, Norway, and Switzerland and therefore are
marked with the symbol shown at the left (crossed-out wheelie bin). The treatment
applied at end of life of these products in these countries shall comply with the
applicable national laws of countries implementing Directive 2002/96EC on Waste of
Electrical and Electronic Equipment (WEEE).
CLASS 1
LASER PRODUCT
!
CAUTION
Use of controls or adjustments of performance or procedures other than those specified in this
manual may result in hazardous radiation exposure.