Alcatel-Lucent 7450 ESS-1, Installation Manual

Page: 69 / 92

Connections and Configurations
7450 ESS-1 Page 69
Telnet Connection
Access the switch after a successful initialization with a Telnet connection from a PC or
workstation connected to the network after the management port (
Figure 18 ) has been configured
using the
bof>address
command (see below). Telnet access provides the same options for user
and administrator access as those available through the console port.
To configure the 7450 ESS-1 for Telnet access, you need to have a device with Telnet software
located on the same network. The 7450 ESS-1 must have a management IP address. The IP
address is manually configured. Each 7450 ESS-1 switch is limited to a total of 7 Telnet or SSH
sessions. For information about configuring switch parameters, refer to the 7450 ESS OS System
Guide. For pinout information, refer to
Appendix B: Pinout Assignments on page 87 .
MAC addresses are listed on a small label on the chassis and on the MDAs. The MAC address
also displays in the
show router arp
command output.
Figure 18: Management Port Connection
CLI Syntax:
bof
address ip-address/mask [primary|secondary]
The ESS-1 must have a management IP address. The IP address is manually configured.
ESS1002
Mgmt Port