1.0 Programming theTransmodulator
To program the Transmodulator (TO-series), place the programming switch in the ON
(upward) position which can be seen from picture below. When you turn the switch in the “ON”
position the programming indicator will light up. While the programming indicator remains lit,
the channel processor is ready to receive data from the PS programmer. When the modulator
has been programmed, programming mode should be deactivated by placing the switch in the
OFF position. The programming indicator light will go out.
To start programming the equipment, Press any button on the PS-003 programmer to turn on
the programmer. The following screenshot below will appear.
You must then select the model you are trying to program. Scroll left
or right
using
the arrows until you get screenshot below
Press the down arrow
and you will then see
“Standard B/G stereo”
on the programmer
screen. This can be seen below
Firmware Version of
programmer
Programmer
