Installation
After having fitted the mounting box and flange with sealing for prefabricated swimming pools,
move on to fitting the light itself. To connect the light to the electricity, the power supply cable must
be pulled through the duct nut.
Tighten the nut carefully in such a way that the cable is secured in the duct. You must leave 1.5 m
of cable coiled around the back of the body of the light to ensure that if necessary, it is possible to
pull the light above the edge of the swimming pool to replace the bulb (Fig. 5). Also tighten all nuts
around the circumference of the light.
Insert the whole light into the mounting box.
Putting into operation
Check that the supply voltage to the light is not greater than AC 12V.
The light must be positioned vertically on the wall of the swimming pool and must be completely
immersed in the water.
Instructions for the remote control
Button functions:
•
Buttons 1 and 2 have no function for this type of light.
•
Buttons 3 and 4 are used to switch the light on and off.
•
The button is used to switch between colours (red, green, blue, multicolour).
•
The button is intended for automatic colour change according to a set time interval
Automatic colour change according to a set time interval.
Switch on the light using button 3 or 4 and button
and select colour. Then press the button
and the quick colour change will be activated.
If two or more lights are installed in the swimming pool they can be controlled by a single remote
control but you cannot synchronize the colour of the lights.
4.
5.
6.
light depth
including casing
number of LED
diodes
light angle
luminosity
voltage
power
consumption
178 mm
red 78 pc
30°
150 cd
12V
18W
green 78 pc
blue 96 pc
Pool light LED 8W/12V with remote control /
5
