ACTIVE ONE ALBERICI
Istruzioni Originali
Rev. 1.00
Pagina 7
4.2 Servo-control board
A 10p flat cable connects the Active One control board to the Servo-board.
Power the Servo-board by the 3p socket J1, according to the following pattern:
230 Vac
24Vac
24Vdc
12Vdc
Pin 3:
line 230Vac
line24Vac
+24Vdc
+12Vdc
Pin 2:
neutral
neutral
0Vdc
0Vdc
Pin 1:
GND
GND
4.2.1
Connections to start the equipment by relay transmission of power supply:
Service line 1 (Pushbutton A): from power supply, connect one end of service line 1 straight to the relevant actuator (i.e.
electrical motor, solenoid, a.s.o.). Connect the other end to pin 1 (COM 1) of J2 connector.
If operation mode is “normally open”, take the switching wire to the 1 actuator from pin 2 (N.O. 1). These wires must
be able to sustain 10 Amps current draw.
If operation mode must be “normally closed”, take the switching wire to the actuator from pin 3 (N.C. 1).
If the actuator works by d.c., take care to connect properly positive and negative poles!
Service line 2 (Pushbutton B): from power supply, connect one end of service line 2 straight to the relevant actuator (i.e.
electrical motor, solenoid, a.s.o.). Connect the other end to pin 4 (COM 2) of J2 connector.
If operation mode is “normally open”, take the switching wire to the 2 actuator from pin 5 (N.O. 2). These wires must
be able to sustain 10 Amps current draw.
If operation mode must be “normally closed”, take the switching wire to the actuator from pin 6 (N.C. 2).
It is possible to disable coin acceptance in any of the following two ways:
a)
Electronically -
Pins 7/8 of green connector J2: provide any Vdc (+) or Vac (line value) to pin 7, and
respectively 0Vdc (-) or Neutral Vac to pin 8.
b)
Mechanically -
move to OFF the dip-switches located on the coin acceptor. Move them back to ON when
you want to resume coin acceptance.
To/from pulse
coin validator
signal on PIN10
OUT 1: LINE 2, N.O.
IN 1: C1 LINE 2
OUT 2: LINE B, N.O.
IN 2: C2 LINE 2
DISABLE: Vac L or Vcc +
DISABLE: Vac N or Vcc -
POWER IN: GND (ac)
POWER IN: 230Vac,
or
24Vac,
or
+24Vdc,
or
+12Vdc
POWER IN: N (ac)
or
- (dc)
OUT 2: LINE B, N.C.
OUT 1: LINE 2, N.C.
POWER TO
EQUIPMENT:
230Vac, or 24Vac,
or +24Vdc, or
+12Vdc
INH –
INH +
N.C. 2
N.O. 2
COM 2
N.C. 1
N.O. 1
COM 1
+ / L
- / N
GND
EQUIPMENT
1
