Mainboard PX915P-2V
28
performance incrementally. In Auto mode, the system automatically determines the best
mode for each device. Options: Auto (Default),Mode0,Mode1,Mode2,Mode3,Mode4.
IDE channel0 /channel1 /Master / Slave UDMA
Ultra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in
your system. As well, your operating environment requires a DMA driver (Windows 95 OSR2
or a third party IDE bus master driver). If your hard drive and your system software both
support Ultra DMA 100, select “Auto” to enable BIOS support.
Options: Auto (Default),Disabled
***OnChip Serial ATA Setting***
On-Chip Serial ATA
This option allows you to select the on-chip Serial ATA operating mode which will
determine how you will use your Serial ATA drives with the other standard IDE drives. This
system can physically attach 2 IDE drives and 4 SATA drives but will have certain limitations
as described below. Options:
Disabled Disable on-chip serial ATA. No Serial ATA devices installed.
Auto(Default) BIOS will auto-detect the presence of any SATA devices.
2 (or 1) IDE d 4 (or 3) SATA drivers
Æ
Enhanced Mode
2 (or 1) IDE d 2 (or 1) SATA drivers (Must connect with SATA1 +3
or with SATA2+4)
Æ
Combined Mode
4 ( or 3 or 2 or 1)SATA drivers
Æ
SATA only
2 (or 1) IDE drivers
Æ
Disabled
Combined Mode Windows
®
98/ME can recognize IDE devices but cannot directly recognize
an SATA device and therefore you must use this mode to allow the SATA
device to simulate an IDE device by assuming the role of one IDE channel
in the system. This means that you will have one available IDE channel
for 2 SATA drives to use (each IDE channel can support 2 IDE drives). If
you were to install all both IDE drives and 4 SATA drives, you will only see
2 of the SATA drives along with the 2 IDE drives.
Enhanced Mode In this mode, you can use all 6 hard disk drives (including 2 IDE drives and
4 SATA drives).
Note:
You cannot use “Enhanced” mode with Windows® 98/ME. It only
supports to install Windows® 2000/ XP if you want to boot from SATA
device. (It’s restriction from Microsoft.)
SATA Only Select this option when you install SATA drives only.
PATA IDE Mode
This option allows you to select an IDE channel for PATA IDE devices. When you install the
SATA device(s) to the SATA1 or 3 or 1+3, this option should be set to channel 1. When you
install the device(s) to the SATA2 or 4 or 2+4, this option should be set to channel 0.
Options: Channel 0 (Default), channel 1
SATA Port
This option will display which IDE channel will be used to the SATA device. Options: SATA2, 4
is channel 1
