Connectors
support SATA 150 Mbps trans
Floppy Dri
The mainboard
360K, 720K, 1.2M,
1.44M and 2.88
e ribbon cables provided in
the packaging.
fer rate.
ust also configure one drive as the master and one drive as the
ave.
E2 (Secondary IDE Connector)
he IDE2 connector can also support a Master and a Slave HDD. The configuration is similar to
E1.
ATA1/ SATA2
he SATA connectors support a transfer rate to 150 MB/s. One SATA connector only can connect
ne serial ATA hard drive disk of each time.
ve Disk Connector: FDD1
provides a standard floppy drive connector (FDC) that supports
M floppy disks. This connector supports the floppy driv
Hard Drive Disk Connectors: IDE1/ IDE2
、
SATA1/ SATA2
The mainboard has a 32-bit enhanced IDE Controller that supports Ultra ATA 33, Ultra ATA 66,
Ultra ATA 100 and Ultra ATA 133. It has two IDE slots, IDE1 and IDE2 for connecting the hard
drive disks. You can expand to connect maximal 4 IDE supported devices, such as hard drive disk,
CD-ROM, 120MB floppy disk, and so on. The mainboard also has two Serial ATA connectors that
IDE1 (Primary IDE Connector)
You can connect up to two hard drive disks to IDE1. If you attach two HDDs, you must use a ribbon
cable with three connectors. You m
sl
ID
T
ID
S
T
o
13
