Mainboard PM73V
10
Line-Out (
Green
)
This port is an output audio port used for connecting to
speakers or a headset. When the multi-channel audio
system is enabled, this port will output audio for the
front speakers.
Mic-In
(Pink)
This port is for connecting to a microphone. When the
multi-channel audio system is enabled, this port will
output audio for your subwoofer/center speakers.
Connectors
Floppy Disk Drive Connector: FLOPPY
The mainboard provides a standard floppy disk drive connector (FLOPPY) that supports 360KB/
720KB/ 1.2MB/ 1.44MB/ 2.88 MB floppy disk drives using a FDD ribbon cable.
Hard Disk Drive Connectors: IDE
The mainboard provides one IDE connector that support Ultra ATA 100/ 66/ 33 IDE devices.
You can attach a maximum of two IDE devices, such as hard disk drive (HDD), CD-ROM,
DVD-ROM, etc. using IDE ribbon cables.
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE
HDDs, you must configure one drive as the master and the other one as the slave.
SATA II Connector: SATA 1/2/3/4
The four SATA II connectors support up to 3 Gbps data transfer rates with SATA RAID 0 and
SATA RAID 1, and one SATA connector only can attach one SATA HDD of each time using
SATA cables.
This mainboard supports RAID 0 & RAID 1 mode;
refer
Appendix II
for more information.
This mainboard supports Super 5.1 Channel Audio Effect, and you can transfer
2-channel to 6-channel audio. See
Appendix I
for more information.
