Albany UltraSecure 3000, Owner'S Manual

Page: 15 / 44

Rev. 9/27/2009 Manual #001451 14
Operation
High Speed Doors
Inspection and Maintenance
Maintenance and inspection work must only be per-
formed by manufacturer trained authorized personnel.
Before beginning the above-mentioned work the power must be disconnected by turning off the
main power switch and locking it. The control unit must be checked to determine there is no power
to it with the appropriate device. All ladders, scaffoldings, or similarly used equipment should corre-
spond with valid safety regulations.
The area around the door must be blocked for traffic. Any spilled lubricating oil, tools and other ma-
terial should be removed from the floor when work has been completed.
The necessary intervals, check-ups and instructions for such work are documented in the
―Inspection Schedule― (see Appendix).
Cleaning
Cleaning and Maintenance of the Panel
Do not use any glass cleansing liquids (contents may be
corrosive)
Never use score cleansers, scrapers, razor blades, spatulas, etc.
Clean with warm water, a small dose of mild plastic cleanser and a soft cloth.
Cleaning and Maintenance of the Side Frame
Dust may be removed with a soft cloth. Harder dirt may be removed with water and general liquid
cleanser.
Grease or oil on the metal surfaces may be removed with solvent containing cleanser.
Do not use a high-pressure cleaning machine.
Clean Door Area
The floor around the side frames may become dirty with lubricants, etc. following maintenance
work. This must be removed quickly.
Tensioning the Panel
The door is furnished with a panel tension system. The bottom profile is pulled down on both sides
by means of a rope. The ropes guard a secure run during closing of the door especially during
heavy wind force.