Part N
umber
6410T0006
Version 4/23/2010
37
Before threading the hinge pin, ensure the Full Vision Panel™ is centered with respect to the door panel.
Lubricate the clips and/or hinge pin with a small amount of light oil (or similar lubricant). This will help
facilitate the threading procedure.
Thread the hinge pin between the loops in the clips. The clips, from each panel, should be alternately
spaced and threaded accordingly.
d. Push the plastic hinge pin in as far as possible. It should travel about three to five feet before becoming
difficult to push.
1) To obtain a better grip on the hinge pin, use a pair of pliers to push the hinge pin in short increments.
Be careful not to bend the hinge pin, which could weaken it.
2) If the hinge pin becomes
jammed on one of the clips,
pull it back a short distance,
twist it slightly, and resume
pushing.
Once it becomes extremely
difficult to continue
pushing the hinge pin, using
a pair of needle nose pliers,
pull it out and away from
the clips as shown in
Figure 36
.
Form hinge pin into a large
loop and thread back into
the clips as shown in
Figure 36.
Continue threading the
hinge pin through the
remaining clips to the end
of the panel.
Pull slack out of the hinge
pin and draw the loop down
until it is
Figure 37.
Repeat this looping process
as required to facilitate
threading of the pin.
FIGURE 36
Summary of Contents for RAPID-ROLL 570
