Albalá Ingenieros GPD2000C01, Manual

Page: 19 / 26

Albalá Ingenieros | Manual GPD2000C01
The following functions of the GPD2000C01 can be performed remotely:
- Adjustment of the thresholds for minimum and maximum current by the antenna.
- Adjustment of the threshold for minimum power supply voltage that should be
available at the connectors.
- Activation of the internal power supply of the module and the voltage it provides to
the antenna.
- Configuration of the error masks that control the behavior of the STATUS LED.
- Supervision of the voltage and current supplied to the antenna and the voltage
provided by the GNSS receivers to which the signal is distributed.
4.3.1. Details of the GPD2000C01 registers
The GPD2000C01 module provides control and status registers that can be read and
written by means of specific commands described in the communication control
module user manuals.
The parameter information grouped in the CONTROL or RAM sections is stored in
volatile memory. Any modifications to the parameters will be lost when the module
power supply is disconnected unless the "EEPROM Save" button within the software
has been pressed.
The STATUS section parameters are read-only and cannot be modified.
The EEPROM section parameters are rarely used and are stored directly in non-volatile
memory.
The parameters that can be controlled and supervised remotely for each version of
the firmware are listed below:
VERSION 1.X
CONTROL
Name add ext msk snmp trap Description
GPD_VCC_DISABLE 0x00 0x01 N N Disable internal VCC
0=Disabled, 1=Enabled
GPD_VCC_5V_3V3_N 0x00 0x02 N N Internal VCC level
0=3.3 V, 1=5 V
VCC_GNSS1_F_MASK 0x01 0x01 N N VCC GNSS Input 1 fail mask
0=Disabled, 1=Enabled
VCC_GNSS2_F_MASK 0x01 0x02 N N VCC GNSS Input 2 fail mask
0=Disabled, 1=Enabled
VCC_GNSS3_F_MASK 0x01 0x04 N N VCC GNSS Input 3 fail mask
0=Disabled, 1=Enabled
VCC_GNSS4_F_MASK 0x01 0x08 N N VCC GNSS Input 4 fail mask
0=Disabled, 1=Enabled
VCC_ANT_F_MASK 0x01 0x10 N N VCC antenna fail mask
0=Disabled, 1=Enabled
ICC_ANT_F_MASK 0x01 0x20 N N ICC antenna fail mask
0=Disabled, 1=Enabled
NO_ANTENNA_MASK 0x01 0x80 N N Antenna presence fail mask
0=Disabled, 1=Enabled
19