Alaxala AX6300S series, Software Manual

Page: 33 / 522

2. Filters
17
Note, however, that statistics for layer2-forwarding or layer3-forwarding is not cleared if
statistics for layer2-and-layer3-forwarding are cleared.
Operation when this parameter is omitted:
Resets statistics for the access list when layer2-forwarding is set and the access list when
layer3-forwarding is set in the specified interface.
Operation when all parameters are omitted:
Resets statistics for the access lists when all relays are set in all interfaces.
Example
Figure 2-9: Result of resetting the standard IPv4 access list statistics
> clear access-filter 1/7 12
Date 2006/03/01 12:00:00 UTC
>
Display items
None
Impact on communication
None
Response messages
Table 2-3: List of response messages for the clear access-filter command
Notes
If this command is executed, MIB information of the axsAccessFilterStats group is also reset.
Message Description
Can't execute this command in standby system. This command cannot be executed on a standby system.
Can't execute. The command could not be executed.
Possible causes are as follows:
•
There are no active BSUs, CSUs, and MSUs. Make sure at
least one BSU, CSU, or MSU is active before re-executing
the command.
• The command cannot be executed because the access list is
being set. Wait a while, and then re-execute the command.
Illegal NIF -- <nif no.> . The specified NIF number is invalid. Make sure the specified
parameter is correct, and then try again.
<nif no.> : NIF number
Illegal Port -- <port no.> . The specified port number is invalid. Make sure the specified
parameter is correct, and then try again.
<port no.> : Port number
No configuration. No access group was set for the Ethernet interface or VLAN
interface. Make sure the specified parameter or access-group
setting is correct, and then try again.
No such access-list. The access list number or the access group of the access list
name you specified has not been set. Make sure the specified
parameter is correct, and then try again.
No such interface. The specified interface has not been configured. Make sure the
specified parameter is correct, and then try again.