Alaxala AX3630S, Software Manual

Page: 532 / 875

21. IEEE802.1X
504
dot1x vlan dynamic timeout quiet-period
Specifies the period of time (in seconds) for maintaining the unauthenticated state on the applicable
interface after an IEEE 802.1X authentication failure. During this period, no EAPOL packets are
sent and received EAPOL packets are ignored. Also, no authentication is performed.
Syntax
To set or change information:
dot1x vlan dynamic timeout quiet-period <seconds>
To delete information:
no dot1x vlan dynamic timeout quiet-period
Input mode
(config)
Parameters
<seconds>
Specifies the period of time (in seconds) for maintaining the unauthenticated state.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 65535
Default behavior
60 seconds is used as the period for maintaining the unauthenticated state.
Impact on communication
None
When the change is applied
When the Switch enters the unauthenticated state due to an authentication failure.
Notes
1. All IEEE 802.1X settings take effect when the
dot1x system-auth-control
command is set.
2. This command takes effect only if the
dot1x vlan dynamic enable
command has been set.
Related commands
dot1x system-auth-control
dot1x vlan dynamic enable