Section 4
Installation
4.1 Mounting
The PD8(F) mounts either in the accessory board space on the power supply or to the
back of a metal enclosure.
4.1.1 Mounting On a Power Supply
1. Remove and save the four mounting screws from the accessory board mounting
space on the power supply.
2. Install 6-32 x 1 1/4” Male-Female standoffs in the four locations where the
screws were removed (the aluminum standoff, if present, is installed in the top
left mounting hole).
3. Mount the PD8(F) to the standoffs using the screws removed in step 1
4. Connect ABC cable(s) appropriately (See section 3.3)
4.1.2 Mounting In a Metal Enclosure
1. Install four 6-32 x 3/4” Female-Female nylon standoffs on the appropriate
mounting studs in the enclosure (the aluminum standoff, if present, is installed
on the top left mounting stud).
2. Mount the PD8(F) to the standoffs using 6-32 x 3/8” screws.
3. Connect ABC cable(s) appropriately (See section 3.3)
AlarmSaf c 2005
PD8
PD8F
MOUNTING
HOLES
Fig 4.1.1
PD8(F) Installation Instructions
10/27/2006, 1:58:40 PM
52-326 Rev B.01
Page 9 of 14
AlarmSaf
65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com
