7
TEST LOCK OPERATION
Before testing, be sure the lock has been powered-
up using the specific instructions in the OI310,
OI311 or OI312 manuals.
1. With key removed, ensure that the turnpiece CAN be
turned freely in either direction and the deadbolt
does NOT retract.
2. Release turnpiece. Insert key and turn key fully
counterclockwise
.
3. Turn the turnpiece and the deadbolt should extend
and retract.
4. Retract deadbolt. Turn key clockwise and remove
key.
The turnpiece
must not
retract or extend the dead-
bolt when turned.
5. While pressing the default access code on the lock
keypad (press "1
2
3
4
5" on the DL1200 / DL1225 /
DL1250 and press "1
2
3
4
5
6" on the DL/PDL1300),
note the following:
•
For each number key pressed, the red LED lights.
•
When the "5" button is pressed (or the "6" button
on the DL/PDL1300):
1. The green LED flashes for approximately 5
seconds, and then
2. The deadbolt can be retracted when the turn-
piece is turned.
6. Test the exit device mounted inside (paddle / egress
bar, etc.) and confirm it is operating correctly.
SEE PROGRAMMING INSTRUCTIONS OI310,
OI311 or OI312 FOR KEYPAD PROGRAMMING
INFORMATION.
Test Step 3
Test Step 5
Test Step 1
Test Step 2
Deadbolt
extended
Test Step 4
Summary of Contents for NARROW STILE ACCESS LOCKS
Page 6: ...6...
