Copyright © 2015 Alarm.com
|
www.alarm.com
|
v5.0
2
LiftMaster MyQ
|
Installation Guide
5)
Select “Add Gateway” and enter the internet gateway’s
serial number.
6)
After a few minutes, the equipment page should show the
internet gateway in the equipment list.
7)
View the LiftMaster Equipment page (Equipment ->
emPower Devices -> LiftMaster) and select the “Learn Mode”
link for the gateway. This will put the internet gateway into
learn mode so that MyQ Control Panel can be added. A
yellow light should turn on at the gateway.
If the yellow light does not turn on, select the “Get
Equipment List” button, wait 1 minute and try “Learn Mode”
again.
8)
After the yellow light is on at the internet gateway, enter
menu > program > MyQ device on the Control Panel (e.g.
880LM). The LED on the gateway will turn blue once the
device is learned in.
9)
Select “Get Equipment List”. This will retrieve the MyQ
Control Panel and link it to the Alarm.com system.
Option 2: Register the Gateway from the Alarm.com Customer
Site
1)
Make sure that the LiftMaster add-on has been added to the
customer’s service plan.
2)
by using customer credentials.
3)
Access garage door registration through emPower -> Garage.
4)
Follow the instructions to add a gateway.
5)
Enter the serial number of the Gateway and continue
6)
Select Add New Device to put the Gateway into learn mode.
7)
After the yellow light is on at the internet gateway, enter
menu > program > MyQ device on the Control Panel (e.g.
880LM). The LED on the gateway will turn blue once the
device is learned in.
8)
Return to the Garage page and click “Check for New
Devices”.
9)
Repeat steps 6-8 if initially unsuccessful. Also check the
model number of your garage door against the complete list
of compatible garage door openers below and make sure the
garage door is compatible.
Troubleshooting
1)
If the yellow command LED does not turn on, reverse the
wires connected to the R and W terminals of the control
panel. Replace the wire if necessary.
2)
If yellow and red LEDs are blinking slowly, the control panel is
not compatible with your garage door opener.
3)
If the yellow and red LEDs are blinking quickly, the control
panel is charging, and may take up to 5 minutes to become
operational.
4)
MyQ gateway “Learn Mode” is active for 3 minutes during
which time devices associated with that gateway will be
inoperable.
