In the box
• ADC-V515 camera
• Mounting bracket
• Power adapter
• Installation guide
• Wall anchors & screws (x2)
Overview
❶
Camera lens
❷
Infrared light
❸
Status light
❹
Ambient light sensor
❺
Microphone
❶
DC power connector
❷
Friction ball joint
❸
Friction hinge joint
❹
Base
❺
Reset / WPS button
❶
Rubber pad
❷
Mounting recess
❸
Speaker
❹
SD card door
Installation
Connect the camera to the Wi-Fi network
AP mode
To ensure sufficient Wi-Fi signal, complete these steps
with the camera near its final location but prior
to mounting.
❶
Connect the camera’s AC power adapter and plug it into
a non-switched outlet.
❷
The camera’s LED will begin to blink white.
If the LED is not white after two minutes, hold down the
Reset button and release when the LED begins to
blink white (about 6 seconds).
❸
On an Internet enabled device, connect to the Wi-Fi
network ADC-V515 (XX:XX:XX) where XX:XX:XX is the
last six characters of the ADC-V515’s MAC address,
which is located on the camera or on the packaging.
❹
On the same device, open a web browser and enter
http://v515install in the URL field. Follow the on-screen
instructions to add the ADC-V515 to the Wi-Fi network.
The LED will be solid green when the connection
is complete.
❺
See the Add the device to an account section to
complete the installation.
Connect the camera to the Wi-Fi network
WPS mode
To ensure sufficient Wi-Fi signal, complete these steps
with the camera near its final location but prior
to mounting.
❶
Connect the camera’s AC power adapter and plug it into
a non-switched outlet.
❷
Hold down the Reset button on the back of the
camera and release when the LED begins to blink blue
(about 3 seconds).
continued
2
3
❶
❸
❷
❹
❺
❺
❶
❷
❸
❹
❶
❷
❸
❹
